Croc Egg Charm Two-Body

Two separate bodies so you can just run two jobs in different colors, rather that trying to setup a multicolor print. I needed it because I don't have white and yellow in the same material sitting around. Pulled into Fusion 360 Mesh mode, split it, repaired, exported.

The slice in this first upload isn't perfect but the error is below the threshold for the slicer to render. I may go back and fix it later to be more perfect.

Recommended usage…

Print just the egg white in white or something translucent, probably ABS/ASA for strength. Then in a second job, print the yolk in a yellow/orange. The original model was intended to be printed with 0.2 layers. Remember that ASA/ABS shrinks about 0.5% more than PLA/PETG.