DragonBurner Dragonfly BMS 7 Fin Mount

This mount requires 2 heatset inserts. A huge bonus with using the Dragonfly BMS is you can use 2 M3 SHCS instead of the tiny M2 or M2.5 required by the Dragonfly BMO. I find the BMS side mount with 2 screws is superior to the BMO top mount.

I recommend ASA-CF for strength and heat resistance. 

I've tested this mount on a V0.2r1 and successfully printed a 12 minute benchy using a CHT nozzle. It required 270C nozzle temps and held up fine.

It should be printed with the back down so the tie-wrap holes are facing up. The STL should already be in the correct orientation.