Sovol SV06 PSU mount bracket - no supports
This is the Sovol SV06 PSU mount by R Reuter, adapted so it can be printed with no supports
4
49
1
274
updated
August 27, 2023
Description
PDFAdaption of https://www.printables.com/model/346977-sovol-sv06-psu-mount-bracket
The original front bracket had considerable overhangs that required supports. I wanted to print in PETG without supports, so I redesigned it.
It should be obvious what side needs to be down on the base plate. Tolerances are tight so make sure you allow for any shrinkage.
You also need to print the rear bracket from the original.
Tags
Model origin
The author remixed this model.
