Charging Stand for Fossil Q Explorist

Based on the Fossil Q Explorist Charging Dock by Samrobmoe you'll see the similarity in the part the watch sits on.

This design has the watch at a 20 degree angle so the magnet in the charging pad is enough to keep it from sliding off. There's also a clip feature to hold the cable in the loop under the watch. The base is a bit smaller.

This is intended for the Fossil Q Explorist. The charging pad recess is 26mm diameter x 4.6mm deep and the cable slot is 4.5mm wide. The cable clip is meant for a 2.8mm diameter cable.

Print instructions

Category: Gadgets Summary

Based on the Fossil Q Explorist Charging Dock by Samrobmoe you'll see the similarity in the part the watch sits on.

This design has the watch at a 20 degree angle so the magnet in the charging pad is enough to keep it from sliding off. There's also a clip feature to hold the cable in the loop under the watch. The base is a bit smaller.

This is intended for the Fossil Q Explorist. The charging pad recess is 26mm diameter x 4.6mm deep and the cable slot is 4.5mm wide. The cable clip is meant for a 2.8mm diameter cable.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Mk2

No

Supports:

No

0.2

Infill:

15

Notes:

Printed with 0.6mm nozzle at 0.2mm layer height with 3 perimeters and 15% infill. Would probably have been fine with no infill. Took 3 hours to print.

It should be printed on its side without any support.