BTT Smart Filiament Sensor Mount for Ender 3v2 Neo with Redrex Dual Gear Extruder

BTT Smart Filiament Sensor Mount for Ender 3v2 Neo with Redrex Dual Gear Extruder

This is remixed from TheKojent's mount because on the Ender 3v2 Neo the filiament didn't line up with the input hole on the Dual Gear Extruder. I also strengthened the part where it mounts on the bar.

The extruder is found at this link https://www.amazon.ca/gp/product/B09H6T3NNT/?tag=stockreport0a-20

I used tinkercad to split the printer mount from the sensor mount and then filled in the area in between. I then added a little to the printer mount to strengthen it from splitting.

Since had the original that TheKojent remixed from slip off I've always used a zip tie to extra secure the mount and never had a problem since. there's a version that has you use the screws that hold the z bracket but I prefer not to touch those.

Print Settings

Printer Brand:

Creality

Printer:

Ender-3 v2

Rafts:

No

Supports:

Yes

Resolution:

.2

Infill:

20%

Filament: ERYONE PETG Black

Notes:

If you use supports block the supports from forming in the part that mounts on the printer or you'll be digging them out with a razor knife.

I used the auto orientation plug in in cura to have it orient the face down. Alternately you can print it as is with supports. I suggest tree supports for ease of removal and block them from forming in the bolt holes.

Category: 3D Printer Parts