Needed Raspberry Zero mount but I did not find small screws in my area to mount the Pi Zero to my printer, So designed this mount for 2020 and 1515 extrutions (Since I am putting a Raspberry Pi Zero in my Voron 0.2 as well) and the Pi attaches to the printed dowels. It is a tight fit so make sure you clean the dowels of any burs before attaching the Pi Zero. It is quite sturdy for not using screws to attach the pi.
2 M5x8 Screws
2 M5 T-nut
I've used ABS for all parts
print settings are:
0.2mm Layer height
18% Infill
3 perimeters
Supports not required
The author marked this model as their own original creation.