Multimeter Holder / Wall Bracket for Duratool D03041

Holds D03041 multimeter and at least two sets of probes / leads

Print Settings

Printer Brand:

Creality

Printer: 

CR-20

Rafts:

Yes

Supports: 

Yes

Resolution:

200

Infill: 

38

Filament: ASA 
 

Notes:

This large print took well over 24H on the CR20 using fairly conservative speeds.
Even with raft, the ASA material warped and split a little at the corners. However these defects appeared minor on the finished item, and the central compartment for the multimeter turned out undistorted.

The item was designed to be printed at a 30 degree angle and using tree supports.

If using ASA then would recommend to use large rafts as possible, and strong contacts between raft and bed; raft and component. Enclosed printing area, fan off.

FreeCAD source model included

Category: Electronics