Gridfinity Caliper with PCB Ruler

Storage for an iGaging ABSOLUTE ORIGIN 6" Caliper and a PCB Ruler with 2 spots for CR32 batteries.  

I printed with 0.3 layer height on a 0.6 nozzle. Should print with any Gridfinity settings you normally use. 

Calipers will need to be open to ~10mm in order to sit at the bottom of the cavity. There should be enough room to turn off the calipers while still in the bin. 

I recommend using magnets in all the magnet holes as this is extremely top heavy, but much more resilient to getting knocked over with the magnets.