Undead Jazz Band in the frame

Undead Jazz Band filament painting using Hueforge and 8 colours

On this painting, i've used beige to make it look a bit different than the classic grayscale. Feel free to avoid beige and bone white if you are looking for a matching “in the frame” painting.

As usual, print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm (This filament painting is very thin).

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA PolyLite Beige
• PLA+ Esun Bone White
• PLA+ Sunlu White

Swap Instructions:

• Start with Black
• At layer #4 (0.4mm) swap to Charcoal Black
• At layer #5 (0.48mm) swap to Cement Gray
• At layer #7 (0.64mm) swap to Grey
• At layer #8 (0.72mm) swap to Light Gray
• At layer #10 (0.88mm) swap to Beige
• At layer #11 (0.96mm) swap to Bone White
• At layer #14 (1.2mm) swap to White for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.