HomePod Mini Mount for Original Prusa Enclosure

❗WARNING❗: I made this mount in a way that it will grip the rubber base of a HomepodMini. When I was trying to remove my homepod from it for the first time, I though that I will ripp the rubber base off :D but I managed to disconect it without any damage. After that I've added a hole a the bottom to push out the rubber base with your finger rather than pulling the whole devide out. Still, please use this mount at your own risk.

The Mount should be installed on a corner of an enclosure and fixed with two 6mm M3 bolts. A HomePod can be just pressed into the place for its base on the mount and should be held snugly.

There are also clips to route the HomePod mini power cord along the enclosure. They should be ideally printed at a 45º angle to distribute the interlayer stress between the “jaw” that holds the cable and the attachment hole. Both gcode and slicer project files that I provided for the clips have them in the suggested orientation, and use a brim with organic supports for stability. The clips can be secured to any enclosure hole with a 4mm M3 bolt.