Ender 3 S1 Pro 5015 Fan Cooler and MPU 9250 Holder -Sprite Extruder

Update:

v2

Offset mod for Touch Sensor added. (Last photo)

Offset Values added.

Setup:

You can find pdf document in the attachments for this. 

Printing:

You have to use PETG or a heat resisdant filament to work properly. You can choose any layer height. For supports: select ‘Support on buildplate only’ option.  You can see the oriantation in the pictures.

Offset values for klipper or stock firmware.

Touch Sensor in the front: 

x_offset: 0
y_offset: -55.15

Touch Sensor offset mod: 

x_offset: -46.8
y_offset: -40.5

Note:

Since the leveling sensor is in a different offset. 2 cm end partition of the heat bed on the Y axis can not be measured due to moving limits. I never printed that big, so no problem for me. Even though, it will not be a problem if you want to print that big, since only thing will not be available should be bed leveling compensation.