Hollow Screw-on Pool Torpedo

Fun Screw-On pool torpedo that glides smoothly through water! You can change the weight of the torpedo depending on whether you would like it to glide or sink more. I used coins, such as pennies, to weigh the torpedo down. Make sure to orientate model in slicer so that flat spots are on buildplate. 

Disclaimer: Once Printed, the screws might be a little tight. Slowly insert the screw and turn it in and outwards to create friction and wear out the pieces so they fit smoothly. 

Print Settings

Supports: Recommended for the overhang on the screw section (but not necessary, just wont look as smooth)

Material: PLA ( Stronger plastics might last longer)

0.2mm Layer Height

3 Walls (For strength since it will take a beating)

15-20% infill (Preferably more,  the stronger side)

Printer: Voxelab Aquila X2