Dart Zone Max Outlaw Spring Spacer

To install this spring spacer, open up the blaster and remove the spring/plunger guide peg. Slide the spacer over the peg, replace peg into blaster, then close up the blaster. 

Closing the blaster may be a pain as the parts have a tendency to try and splay open, but it can be done. 

The .5in spring spacer should yield between 140 and 145 fps, and I haven't tested the .25, but you can probably expect somewhere between stock and 145fps. 

You may be able to stack the two spring spacer and achieve even higher, but I wasn't able to get the blaster to close. 

Don't have a printer? Order from OOD! Affiliate link!