Door stop robot

The robot is stuck under the door!

Don't have a 3D printer? Just want one already printed and assembled? buy one at my shop

I printed both STL files on the same bed with supports and raft, in PLA, 0.2mm layer height, 1.2mm shell and 10% infill.

This model fits doors with about 1 cm clearance under the door.

The head requires support to print the head-body connector, also, due to the angle of the connector it really has a hard time sticking to the build plate and I couldn't print it without a raft

The body does not require support, if you slice it with Cura with supports enabled Cura will generate a little bit of support under the lower hand, this is actually a good thing because the arm is too heavy and unbalanced for the hand to bed contact area, while a raft isn't strictly required it will help here.

Made with SketchUp Make, fixed with Microsoft 3D Builder, sliced with Cura and printed on a Robo 3D R1+