Raspberry Pi and 2-Ch Relay Case

I wanted a case to keep my Raspberry Pi 3B+ and Relay board covered while also having a camera and temperature sensor to monitor/control my Garage using Homekit.I'm running HAP-NodeJS to run everything on the Pi.

I used Thing:1568750 for the camera case.

The relay can be found here: SunFounder 2 Channel Relay

The case doesn't require any screws to assemble. I glued the swivel piece to the top piece of the case and haven't had any issues but you could probably drill out the center for a screw.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Doesn't Matter

Supports:

No

Infill:

30%