JFJ Easy Pro Bracket

The support bracket in our JFJ Easy Pro CD Repair machine cracked and we were unable to find where to buy a replacement.  So, I reverse engineered the bracket and came up with this.

I printed it out of PLA at 0.2 layer height and 100% infill.

The mounting holes may vary a bit because they are mounted using rivets through the machine cover and the holes appeared to be made by melting the holes in the lid.  The mounting holes can be drilled out a little larger if needed to fit.

Since the original bracket was mounted with rivets, you will need to buy some ~20 mm long bolts and corresponding washers and nuts to mount the new bracket.