Angel lights for rc crawler/model

The files are split based on the filament needed.

in the opaque parts you have the iris and two variants of the case:

• a round one
• one that has a mount that uses an m3 screw (you will have to mirror along x or y to get both sides).

The translucent part is the insert that will let the light shine through (I used translucent PETG, without any tint and a red light to get the effect in the pictures).

Prerequisites:

• translucent filament
• opaque filament
• 5mm round LEDs
• M3 screws if you print the variant that has a screw mount
• transparent glue (superglue)

Instructions:

• In prints without supports in the provided orientation, the resolution isn't relevant, the models do not have fine details.
• Print the translucent part at 100% infill, the light will be more consistent.
• The easiest way to assemble is to put a bit of glue on the chamfered edge of the translucent part and insert it into the case. Drop a very small amount of glue (if you use more it will spill out) in the space left for the iris and place the iris on top.
• depending of the tolerances of the LEDs you might need to either enlarge the hole with a drill or glue it in place or (if you are really lucky) the LED will friction fit.