Sovol SV04 Right Extruder Height Adjustment

Allows you to tweak minor adjustments to the right extruder's height.

From the orginal: If you need to adjust it up or down a poofteenth of a millimeter then at least this will let you know how big a poofteenth you've moved it. Each graduation equates to a vertical movement of [approx] 0.02mm. It should be fairly obvious, but + is up, - is down.

The part with the scale simply slips over the top edge of the extruder carrier and the cap fits over the original adjusting knob.

Dont forget you need to loosen the 4 grub screws on the sides first, and re-tighten after.

The models are merged and should print with the main model using extruder 1 and text using extruder 2. They do require both extruders to be reasonably well calibrated to start with.

If your extruders arent well calibrated, you can ungroup the models in (Cura) slicer and move them around slightly or print separately.

Or you could use the ‘Top Layer’ version which is slightly more forgiving but generates a big support inside the cap.

Print at 0.2mm with supports if needed. Break off the supports from the base.

Remixed EvoCivics model to leverage the SV04 dual printing capabilities.