Bambu Labs Spool Dock

I was tired of having to lay my Bambu Labs spools on their side on my filament shelves and made this. It's super simple, but I couldn't find one that already existed.

It's about an hour to print and I tried to reduce filament use as much as I could without sacrificing it being able to hold a spool still.

There are spaces on the bottom side to add rubber feet without raising the center of gravity or having the feet pop off, as well as spots in the wheel well for rubber feet, to keep the spool from rolling.

The tolerances aren't too tight, so feel free to go with larger layer heights to get a faster print.