Dart Zone Max Outlaw Replacement Frontends

To install, start by butterflying the shell. Remove the original frontend. Drop in the new frontend and then button up the shell. 

For printing, I like to print with the front on the build plate, with some supports for the larger half-circle cutout, and the small bit that will overhang no matter the orientation / configuration. 

Speaking of configurations! There are 4 to choose from!

1. Stock replacement frontend - this is a slanted frontend that doesn't have the round bit protruding, it yields a cleaner blaster look. 
2. Extended Frontend - A longer version of the Stock Replacement frontend. 
3. Flat Face - A flat faced frontend. This is seen in the profile picture of the page. 
4. Extended Flat Face - An extended version of the Flat Face.

Other mods shown:

Dart Zone Max Outlaw Front Picatinny (and others)

Dart Zone Max Outlaw Cosmetic Plates

Dart Zone Max Outlaw Safety Delete

Dart Zone Outlaw Replacement Cylinder

Don't have a printer? Order from OOD! Affiliate link!