Parametric Honda Motorcycle Bar End Spacers

These are spacers for Honda motorcycle bar end weights. I created them after having my CB300R grips replaced with Koso Apollo heated grips. The Koso grips are 8mm longer than the stock grips, causing my bar end weights to no longer fit.

I print these with 0.3mm layer height, 100% infill, and 3 perimeters to maximize strength. You will need two M6x60mm flat head screws to fasten the grips to your handlebars.

This model has been tested on a Honda CB300R and should fit all Honda models. The model is parametric, so you can lengthen or shorten the spacers according to your needs.

Check out my fully-printed bar ends if you are looking to completely replace the bar end weights: https://www.printables.com/model/545203-honda-motorcycle-bar-ends.