Dymo Rhino 4200 Case

A remix of @Whity and @Yanev's parametric box.  This one is adapted to protect a Dymo Rhino 4200 label printer and its accessories.

There are slots to hold a spare set of batteries, two 19mm tapes and three 12mm tapes.  Why those?  Well, that's what I had :D

The cut button is accessible with the printer in the case and there is a slot for the label to exit so you can print labels without removing it from the case.  Shorter labels might not stick completely out but can be fished out or the printer can be easily removed from the box.

You may want to apply variable layer height to the slope in the lid to get a smoother surface - or perhaps just tune your filament better than I did.  I just used the scraper to smooth it out a bit and it's been fine thrown in my toolbox.

Screws required:  six M3x30 screws - either button head or socket head cap screws.

Customised interior for Dymo and storage of accessories.