Honda Motorcycle Bar Ends

These are bar ends for Honda motorcycles. I created them after having my CB300R grips replaced with Koso Apollo heated grips. The Koso grips are 8mm longer than the stock grips, causing my bar end weights to no longer fit.

Bar ends should be strong to support the weight of the bike in the event of a fall. I print these with 0.3mm layer height, 100% infill, and 3 perimeters. You can experiment with larger layer heights if you have a larger nozzle. The stock bar ends are fastened with M6x50mm flat head screws. The bar ends for Koso Apollo grips are fastened with M6x60mm flat head screws.

This model has been tested on a Honda CB300R and should fit all Honda models. The model is parametric, so it may fit other motorcycle makes and models as well.

Check out my parametric bar end spacers if you would rather use the stock weights with your grips: https://www.printables.com/model/546885-parametric-honda-motorcycle-bar-end-spacers.

Print Settings:

• Layer Height: 0.3mm
• Infill: 100%
• Perimeters: 3

Hardware:

• M6x50mm flat head screws