Yet another phone/tablet stand

Here is my take on the phone/tablet stand.  I tried several of the open models and was looking for something a little sturdier so I closed the triangle.  The design is symmetrical so orientation to either side works.  I've tested it several times and get best results with 0.20mm layer, 4 walls, 100% speed, in PLApro.  0.25mm worked not to bad with a couple marks on the overhangs but 0.30mm had stringing in a couple places.  I've included a couple of remixes:

• 4 v1 is my original design that holds a cell phone or 8 inch tablet, has relief for a pop socket, charging cable and channel for the charging cable to run through;
• 4 v2 is a narrow version of the same thing to cut down on time (40mm narrower);
• 4b v1 no relief for the pop socket;
• 4b v2 no relief for the pop socket and narrower;
• 4c v1 holds 2 phones (seems silly but I had a request).

Please Enjoy and let me know how it goes :)