HMS Spool Carrier - the one to carry all of them spools we stack!

i needed some fitted spool holders for the cabinet below the printer.
seeing the simple design @JERRY created for the IKEA SAMLA box, I redesigned it to fit my needs.

This now fits into drawers, on shelves, into cabinets or just onto your workbench or countertop. 

depending on the length you need, print 2 ends and a mid part at least every 25 cm to support the alu rod or pipe (8mm diameter). 

the end pieces have a snuck fitting, just rotate the rods in.
the mid parts have a slightly bigger hole to make it easier to slide on.

during testing I printed some 8mm pla rods, that were (suprisingly) indestructible without brutal force. so if you're desperate, can't wait or broke, just print them - just make sure to give them 1,5mm walls and 25% infill at least. in addition, reduce the distance between the mid pieces from about 25 to 15cm this will allow shorter rods as a positive sidekick. also, good luck on bedslingers... 

printables wants to know what I changed. A typo.