Battery Dispenser - 36x AAA - Stackable

Se zásobníkem na baterky jsem moc spokojen, děkuji.

Printed in PLA+ and glued side on with superglue. Works pretty well, but batteries need a little encouraging to roll down when filling it sometimes

Works well, needs an occasional bump for batteries to flow down. Easy and compact storage!

Good storage, but a bit tricky for me to get the batteries out.

A bit hard to asemble, but really nice when built.

Good model, but make sure to load the batteries one at a time in case one turns. Thankfully the slats on the side allow for something like tweezers to turn the battery if it does. It does tend to still jam when removing the batteries though. I think the issue is those same slats sometimes hook on the positive side of the battery.

Printed side wall with different PLA.

Looks very nice when printed. Batteries do het stuck every now and then.

Printed both the AAA and the AA version in white PLA.
I found the batteries would sometimes still rotate and jam while loading, but since the side is detachable, this isnt really an issue.

good model

Nice design again. I done minor tweaks, like lowered thickness of wall. Will see if it will jam or not:)