The Division - Shoulder Beacon

NOTE: SEE v3 HERE: http://www.thingiverse.com/thing:1411233

Here is a costume prop for Tom Clancy's The Division video game. It's some kind of shoulder beacon / gizmo that all the characters wear. I'm not really sure what it does in the game, but if you're making a costume for The Division, you'll need one.

Specs:

*Dimensions: 4.250"W x 2.250"D x 1.080"H (assembled)
*Volume: 1.08 cubic inches (all parts combined)
*Weight: ~0.04 pounds (all parts combined)

Files:

*Top of housing: PTW-00-1-PT-0232 (The Division, Shoulder Beacon, Top).STL
*Bottom of housing: PTW-00-1-PT-0233 (The Division, Shoulder Beacon, Bottom).STL
*Lens: PTW-00-1-PT-0234 (The Division, Shoulder Beacon, Lens).STL
*Opaque center of lens: PTW-00-1-PT-0235 (The Division, Shoulder Beacon, Lens Center).STL

Needed to complete assembly:

• Screws for case
• Orange LED(s), with batteries
  NOTES:

• .STL names do not match .SLDPRT name because Da Vinci will not print file names over 56 characters.
• .STL files oriented for printing.
• Supports are needed to print the top housing. No supports needed for printing other parts.

Print instructions

Category: Props Summary

NOTE: SEE v3 HERE: http://www.thingiverse.com/thing:1411233

Here is a costume prop for Tom Clancy's The Division video game. It's some kind of shoulder beacon / gizmo that all the characters wear. I'm not really sure what it does in the game, but if you're making a costume for The Division, you'll need one.

Specs:

*Dimensions: 4.250"W x 2.250"D x 1.080"H (assembled)
*Volume: 1.08 cubic inches (all parts combined)
*Weight: ~0.04 pounds (all parts combined)

Files:

*Top of housing: PTW-00-1-PT-0232 (The Division, Shoulder Beacon, Top).STL
*Bottom of housing: PTW-00-1-PT-0233 (The Division, Shoulder Beacon, Bottom).STL
*Lens: PTW-00-1-PT-0234 (The Division, Shoulder Beacon, Lens).STL
*Opaque center of lens: PTW-00-1-PT-0235 (The Division, Shoulder Beacon, Lens Center).STL

Needed to complete assembly:

• Screws for case
• Orange LED(s), with batteries
  NOTES:

• .STL names do not match .SLDPRT name because Da Vinci will not print file names over 56 characters.
• .STL files oriented for printing.

• Supports are needed to print the top housing. No supports needed for printing other parts.

  Instructions

  1. Print the top housing with supports.
  2. Print the bottom housing, and lens center.
  3. Print the lens using a transparent material (e.g. clear PLA).
  4. If necessary, trim the flange on the lens until it fits into the top housing.
  5. While they may not print well, there are screw holes, and bosses, in the top and bottom housings. If they print sealed up, just drill them out.
  6. Put one or more orange LEDs inside the lens. Wire resistors and batteries to them, appropriately.
  7. "Save what remains." ;-)