Modular stand for 425 g CO2 cylinders / bottles (SodaStream, Brita and others)

A modular stand for 425 g CO2 cylinders / bottles used in home water carbonators like the SodaStream system. The stand consists of one end and one intermediate piece design, which are connected like a jigsaw puzzle. Tolerances on the puzzle interface are 0.3 mm all around, which should be fine for most FDM printers.

A stand-alone “single" version of the design is also provided, in case you don't have more than one bottle to store.

Print settings

• Layer height 0.24 - 0.3 mm
• Line width 0.42 mm
• Infill 10 - 25%
• 3 wall lines
• 3 bottom layers
• 5 top layers
• Supports not required

Approximate print times @ 60 mm/s: Single 2:30 h / End piece 2:45 h / Intermediate piece 2:55 h