Simple Hygrometer Stand

A simple hygrometer holder with fire and snowflake cutouts above the temperature readout and water droplet cutouts below the humidity readout. Fits the standard rectangular LCD hygrometer available many places online. I purchased these in a 4 pack on Amazon.

Prints easily face down with no support needed. The fit is a bit snug, and takes some force to get the hygrometer past the clips into place. After lining it up, I pressed one side all the way through at a time. If you find it too difficult to assemble, you may be able to scale it up slightly to make it easier, but I have not tried this. Enjoy!

Buy Me a Coffee

Printed in PLA at 100% infill with 3 perimeter walls and monotonic top/bottom order in Cura slicer.