Maze

Just a picture I liked.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA+ Fremover Black Transmission Distance: 2
• PLA PolyLite Dark Blue Transmission Distance: 0.5
• PLA PolyLite Purple Transmission Distance: 0.5
• PLA PolyLite Blue Transmission Distance: 2
• PLA PolyLite Aqua Blue Transmission Distance: 4
• PLA PolyLite Lime Green Transmission Distance: 6.5
• PLA PolyLite Lemon Yellow Transmission Distance: 6.5
• PLA PolyTerra Savannah Yellow Transmission Distance: 3.5
• PLA PolyTerra Sunrise Orange Transmission Distance: 3.5
• PLA PolyLite Red Transmission Distance: 6
• PLA PolyLite Pink Transmission Distance: 4.5
• PLA PolyLite White Transmission Distance: 5

Swap Instructions:

1. Start with Black
2. At layer #10 (0.88mm) swap to Dark Blue
3. At layer #11 (0.96mm) swap to Purple
4. At layer #12 (1.04mm) swap to Blue
5. At layer #13 (1.12mm) swap to Aqua Blue
6. At layer #14 (1.2mm) swap to Lime Green
7. At layer #15 (1.28mm) swap to Lemon Yellow
8. At layer #16 (1.36mm) swap to Savannah Yellow
9. At layer #17 (1.44mm) swap to Sunrise Orange
10. At layer #19 (1.6mm) swap to Red
11. At layer #21 (1.76mm) swap to Pink
12. At layer #22 (1.84mm) swap to White for the rest.

Not all of these colors are necessary, but it was fun. You can skip colors if you don't have them, and it will probably turn out ok.

3mf file has my settings in it and layer swaps already configured. As pictured.
It is not recommended to resize Hueforge prints. I've only provided 1 size for this print.
If you wish to swap to a different filament, just try to find one with a similar TD.

Picture credit: Stable Diffusion XL
Show polymaker some love for their amazing support of Hueforge: https://us.polymaker.com/