Bambu Carbon / P1P Infinity Poop Chute

I was tired of having to manually empty the waste bucket on my Bambu printer, so I designed something that would work better for my application.

This infinity chute is designed to fit on the back of the printer, extend a couple of inches to the edge of the table, and then drop the filament waste into a trash can below.

The design uses 2 x 5mm x 3mm magnets that are press fitted into the holes after printing.  However, in lieu of magnets, I think some double sided or mounting tape would service as a good substitute.

Printed in PLA at 0.2mm layer height oriented with left side of ramp facing down on the build plate.