Begode MTEN4 EUC Stand

I remixed a popular EUC Stand to be one single unit (Assembly no longer needed) and resized it to fit the Begode Mten4. The wheel doesn't sit perfectly but would stay in place and not tip over when knocked from the side.

For best result, use 0.6mm nozzle or larger. 

Filament: PLA, but PETG or ABS would also work. Expect to use 160-180g of filament.

Wall (Perimeter): 3 walls with 0.6mm nozzle (1.8mm) or 4 walls with 0.4mm nozzle (1.6mm)

Infill: 15% Cubic

Make sure there is at least 4-5 top layers (1mm and more)

Tips

1. Make sure z offset isn't too close, if the nozzle is too close it will build up filament somewhere along the print and knock the print over.
2. Make sure fan is on 100% when close to the top, there's an overhang at the top part where the EUC rest on.