Libertango - Ethernet Faceplates

This is part of a collection of wall faceplates and frames. The design is intended to be mutually compatible (but not identical) with ABB Tango.

Use along with faceplate frames.

OpenSCAD sources are available in the GitHub project.

Use 2.5mm round head screws.

Flat design

The flat design is a little easier to print. Print the models upside down and enable supports, which will be used for a few small details.

Round design

The round design is harder to print, but the final look is a little more appealing than the flat one.

• Print the design upright, supports are not needed (bridging will be used).
• Use an adaptive layer height of 0.2-0.05mm.
• Infill should be at least 30%, lest the top surface's quality will likely suffer.