Anycubic i3 Mega (S) Raspberry Pi 3 Model B Mountable Case

A (kind of) Remix of ScottyDoesKnow's Raspberry Pi 4 Case. Realistically all that I used were the brackets (that I shortened a bit) and the design for the holes for the brackets.

Printed on my Anycubic i3 Mega:

Layer Height: 0.3mm

Filament: DASFILAMENT Clear PETG

Supports: Yes

Infill: 100%

Notes:

PiHolder_Top has some sequential bridging built-in for the upper part of the screwhole. ONLY SUPPORT THE OUTER RING OF THE SCREWHOLE. The easiest way is to just use the *.3mf file and import.

For the full model you need to print:

1 x PiHolder_Top
1 x PiHolder_Bottom
2 x Bracket_Shortened

This model requires some Heat-Set Inserts and Screws:

4 x Heat-Set Insert M3 x 6 x 5
4 x Screw M3 x 8 (or longer, but will stick out at the bottom)

Unfortunately I do not have a Rasperry Pi 4, so I cannot test if it fits.