Elegoo Neptune4 filament guide with filament sensor - V2

It's a piece of work that combines a filament guide and the original filament detector stand.

You’ll need to add two piece of support on two sides for the PTFE holder.

A 608 bearing is needed. And just add 2 short piece of PTFE tube (lower one could be shorter for avoiding higher printing collision) and screw the detector in the original screw to the tiny base. Cable tie may help hold the PTFE tube.

It works great on my Neptune4! Extremely smooth. I think it will works on the bigger machines. Thanks for @cdburgess's feedback.

Hope you enjoy this work. ʕ •ᴥ•ʔ

Your comments and suggestions are welcome!