Stabbed by Pen

Pen holder for macabre people.

There are 2 versions, the other is suitable for pencils and the other for ballpoint pens. Pen-version didn't give enough support for the pen and I didn't wanted to make torso bigger, so I added small tube. Tube is very tight fit and if your printer is well tuned, you don't need glue to hold it in place. If it feel too tight, just resize the tube a little bit smaller. Tube needs only 2 grams of filament.

This was a request from Reddit user PorBorSoul.

Print instructions

Unassociated tags: pen holder, pencil holder

Category: Office Summary

Pen holder for macabre people.

There are 2 versions, the other is suitable for pencils and the other for ballpoint pens. Pen-version didn't give enough support for the pen and I didn't wanted to make torso bigger, so I added small tube. Tube is very tight fit and if your printer is well tuned, you don't need glue to hold it in place. If it feel too tight, just resize the tube a little bit smaller. Tube needs only 2 grams of filament.

This was a request from Reddit user PorBorSoul.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

</div>Rafts:

No

Supports:

No

</div>Resolution:

0.2

Infill:

10%

</div>
Filament:

Fillamentum and BQ PLA
Notes: </p>

Use adaptive layers to get better looking top layers. Change filament after layer 4.

When printed with skirt, 3 walls and 5 top layers pencilbody.stl takes 14 grams (4.82m) of filament and with 60mm/s speed it's ready in little over 2 hours.