DN-Badge-Hex-Skill-Plug-version-SAO

Adds a standard 6 pin SAO connector for your Darknet-NG Badge. 
Includes both Horizontal and Vertical.
Model is pressure fit, but probably a good idea to use some 5 minute epoxy after soldering. 

Also include is tool to push SAO connector into place, and doubles as a tool to outline the PCB for cutting. (Put the SAO on the PCB prototyping board, push the pins through the center of the tool on the back, and outline with a sharpie; Slowly cutting it down) You can use Tin snips to cut the PCB, just be sure to wear PPE. (Safety glasses, and a mask)

Quick fix 8/4/23 Vertical was upside down. please use "Hex Skill Vertical - Fixed"

Original author is Gator_Byte. See you at DEFCON 31!