OpenMower Cover UI plate for YardForce SA600H and similar

A Cover UI Plate, Speaker holder, GPS-SMA Plug, for my https://openmower.de/ build.

Fit for YardForce SA600H (and similar models).

Update 08/17/2023:

If your main interest is the mount of your speaker, better check this alternative sound box creation, as it's much better protected against top-water.

Update 08/03/2023:

Attention: It turns out, that even with the additional YardForce Top-Cover, this design has not enough top-water protection! You need to add some kind of plastic-cap to protect your OpenMower electronics. 

My major Print values:

• PLA, 0.4mm Nozzle, 0.2mm layer height
• Print up-side-down
• Print-bed- support required (but with no other supports!)
• 15% Gyroid
• See pictures for more info