PCKT VRTCL Vape Stand + Raised Button

Two models to improve the PCKT VRTCL vape greatly, both have been thoroughly tested by yours truly.

• A sleek stand for the PCKT VRTCL, which annoyingly doesn't have a flat bottom and can't stand up on it's own. Includes a cutout at the bottom so the stand can be left on while charging. The stand easily slides on and off with a snug pressure fit. 

• A raised button overlay for the PCKT VRTCL, which annoyingly has a completely flush button that can be hard to press. 
  1. Print this overlay at 0.1mm layer height.
  2. Press button 5x to turn the vape off.
  3. Put a VERY small drop of superglue on the center of the vape's button.
  4. Use fine-tipped tweezers to place the printed overlay on top of the button and center it as best you can. Apply even pressure for a minute or two until glue dries.
  5. Press button 5x to turn vape back on.