Gardena Wallmount for Rainwater Pipe (D=100mm)

Hi,
Super design, but could you make it for pipes with a diameter of 78 mm? Thanks in advance

Fertig. Kleine Hinweise meinerseits:
1. Use more infill for sturdiness. 12% is in my opinion to low, especially when pulling the hose a bit stronger or using more hose in general. I'd say go at least 20%.

2. Print at 102%. It'll make adding the screws a bit easier and gives you a tad more breathing room. May depend on your PETG but it would have helped me :)

3. FLAT head screws preferred and even a tiny bit longer than described for extra fitting. M22 should do already.

Otherwise, works. May have to reprint it in case it breaks (from low infill).
Suggestion to designer: please add a few images on how to put it on in what order. Otherwise, good work! Pics later(ish)

Würde mich noch freuen zu erfahren, wie der Gartenschlauchaufroller genau heißt :)