Vise with Metal Support

I did like the orginal Vise from "The Goofy" very much, but I could not print the Threads good enough. The Nut would not insert into the Rod.

This is why I had some Metal Parts included instead. Now it works like a charm

Parts

• 2 M12 Nuts
• 2 M12 Rod with 102 mm of length
• 2 Main Gears(2)
• 1 Sliding Jaw(2)
• The Remaining parts from the original Vise: http://www.thingiverse.com/thing:2064269

Instructions

• Print the Parts
• Cut the Threads
• Form a nice Thread into the new Sliding Jaw. Make sure to get a perfect 90deg angle

( I used a Drill rig)

• Glue and insert the Rods into the Sliding Jaw
• Insert the Nuts into Main Gear
• Assemble rest of the Vise from the original instructions.

Happy Tooling!