eLeave istick pico vape holster with "snap" - easy to print without overhangs

This is a remix of melinos eleaf istick pico holder.

My remix is without overhangs and a little snap to hold the vape in place. It is easy to release but strong enouth to hold it in place when you are running.

I have also enlarged the slot, so now wider belts will fit up to 45mm. All overhangs have been set to 45 °, making the model very easy to print. So you do not need to support or have to worry about whether the print succeeds.

I recomment to print this in PETG or ABS. So use a brim!

Print instructions

If you use TPU, print it slow!