Wyze Camera Mount for Original Prusa Enclosure

A simple yet effective bracket designed to seamlessly mount a Wyze camera in the corner of the Prusa Original Enclosure. It uses a single M3 bolt (accepts up to 20mm length).

I printed my vertical, but the bracket that holds the camera is mounted offset from the center of the mount so that it can be more easily printed horizontally if one wishes.

The camera mount comes in two models with a slight variation in the offset position in order to provide more options to suit your specific enclosure configuration.

Non-Printed Parts Needed:

1 x M3 bolt (up to 20mm)

Zip-ties for cable management

Print Settings

I printed this one in PLA with a 0.4mm nozzle, 0.2mm layer height, and 4 perimeters.  You many need to use a brim depending on your bed adhesion.

I may go back and reprint it in PETG if it shows any signs of deformation over time, but I'm going to see how well this one works first.