Microphone Capsule Holder

This is a holder for 10mm microphone capsules (EM272, AOM-5024, et al.) that allows a cheap lapel mic windscreen to be placed on top. 

Drill a 15/32 hole in your enclosure, then glue this in from the inside. Wire your microphone and insert from the outside. Then add some hot glue where the wire comes through. Put a cheap lapel mic windscreen on top. This creates a watertight, but replaceable microphone for an outdoor enclosure. I used it to create a self contained outdoor BirdNet-Pi unit.

There are two STLs, one being 24 mm tall, and the other 30mm. 

They printed well for me with default Bambu Studio settings, PLA, .2mm layer height. No supports necessary.