MH-ET Live D1 mini ESP32 Case

For a small project I needed a narrow case for my ESP32. Of course I found appropriate templates - only I was not satisfied with them. Especially the fact that the lid had too much play and then you would have had to glue this.

Therefore, I have unceremoniously constructed a new housing and made the lid dimensionally accurate, so that it clamps and you can do without glue.

Other highlights:

• A hole in the bottom to be able to push the board out from behind e.g. with a toothpick
• lugs on the lid to fix the board nicely
• symbol in the lid to ensure good ventilation of the board
• a hole for the visibility of the two status LEDs
• and so that the lid can be removed again, there is a recess for a screwdriver.

My goal is always to include original 3D file so you are able to change designs according your needs.