Prusa Mini Support Legs

After creating (https://www.prusaprinters.org/prints/40128-prusa-mini-xz-support) I still found that when printing tall thin parts the Mini would knock them over if moving fast over long distances. I attributed this to the small amount of flex between the foam legs and the XZ support.

The legs connect to the 3030 aluminium extrusions using two M5 x 12 mm hexagon head cap screws and T nuts. This allows you to place them pretty much anywhere. They also consist of a leg and screw that allows you to adjust the height of each one individually.

I really like the look and so far looks like it helps to reduce flex as I haven't knocked over any more tall parts since the upgrade.

Print instructions

I printed everything at 0.2 layer height with 3 perimeters. There is also no need for supports.