Bambu Labs P1S / P1P iPhone Holder

A Remix of SkyGuys great iPhone stand for the P1P.

This version has a few differences:

Easier to print.

Internal cable management. 

Does not block the top from having a panel installed.

Supports P1S.

Supports the same phones.

Support is needed for the base but its very minor, I did try a sacrificial bridge but was harder to remove than support and made installing the screw harder.

2X M3 countersunk screws from 6-12mm to attach the screen to stand and a 10+mm M3 screw (button head or one of the screws used to secure the machine in shipping works too)

*** Its important to thread the cable through the hole in the top first, then through the base before screwing it down, then the stand and then screw on the case back. Don't over torque the base screw as its just in plastic and will strip ***

*** Another important thing to note is that you make sure the bit screwed into inside the machine is facing away from the print head or it will trigger a “ face plate has come off error” ***

*** After a year or so of use I would advise putting a bit of thin double sided tape on the stand as well as the screw. The plastic is a bit thin (hole in the chassis is the limiting factor) so if you bump it too hard you can break that part , tape makes it a bit more robust. *** 

Base updated for the P1S ,  updated the model for much easier printing and routing cabling internally.