I will add photos once I have everything tidied up a bit
This houses the RPi so that the SD card can be accessed. All connectors are otherwise locked up inside the enclosure. I modeled a couple small support tabs inside the card slot so you can print with otherwise no support. Just cut these small pieces out after printing.
The back has a location to mount a 30x30x7 fan to cool the Pi.
You can mount the enclosure vertically with T-nuts through three of the side holes. Mount either to right or left side. Or print the tilt wedge so it will tilt back a bit for better visibility while still clearing the table. The small bracket arm will steady the enclosure by attaching it to the frame extrusion.
The author marked this model as their own original creation.
