ABS-olutly small Futt-Futt (finger putt-putt; ABS printable)

challenge your friends to a game of futt-futt and they're bound to say "what's that?" until they understand the pun-- finger putt-putt!
Ya' gotta' git dee litt-al da wite-a ball from da teeny tee ta da itsy a hole! (tats a Dorf on Golf joke :-)
18 holes now.

Print instructions

Category: Games Summary

challenge your friends to a game of futt-futt and they're bound to say "what's that?" until they understand the pun-- finger putt-putt!
Ya' gotta' git dee litt-al da wite-a ball from da teeny tee ta da itsy a hole! (tats a Dorf on Golf joke :)
18 holes now.

Print Settings

Printer:

da-vinci 2.0a duo (w/ repetier) (no longer have this printer)

Rafts:

No

No

Resolution:

0.3mm

most parts: 20% hexagonal

Notes:

• ⛳️ hole 9 needs supports on the loop
ABS ball and putter infill: solid 3mm brim on ball 2 bottoms 3 tops 2 perimeters 🔥 100 C bed temp < 3 minutes per layer enclose printer use a smooth (clean) print surface print 4 or more balls at a time print all ⛳️ holes with 20% hexagonal fill and extruder temp of about 🔥 220C (ABS) instead of the default 210C (print 🔥 hot)

note: pla may be better for this. also, for abs, you may have better luck with 10% infill for the holes. Post-Printing

use acetone for strength

first, clean out tubes to make sure the balls can fit through.
brush it on.

How I Designed This

first draft on paper.
then in inventor and later fusion 360