Sovol SV06 Display Back Cover

This is a Display Back Cover for your Sovol SV06. I give credit to "Colo3D" for the display cover part. I just removed the Tool holder from his design and added a little bit stabilisation.

There are two versions: One with buildIn supports which can be easily removed and one without. Your choice what your printer can print better! My SV06 printed the modell without any support perfectly!

If you print the "without buildIn supports" version, be sure to add "Supports touching the build plate" it is required to hold up the area inside where the screws go through.

You will need 4 M3 X 12 (or 10) mm screws to replace the shorter ones that were removed.

Also, when you are preparing to put your display back on your machine, be sure the plug the cables back into the correct set of pins.

Print Settings

Printer Brand:

Sovol 3D

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2

Infill:

Filament: Your Choice PLA/PETG/ASA Your Choice